![]() Name: Scotts standard broadcast spreader instruction manual. Do not leave spreader open when making turns.Īdobe InDesign CS5 (7.0) Adobe PDF Library 9.Scotts standard broadcast spreader instruction manual > Download Scotts standard broadcast spreader instruction manual Scotts standard broadcast spreader instruction manual > Read Online Scotts standard broadcast spreader instruction manual Spreader Overlap: Using wheel tracks as a guide, make each pass 5 feet from the previous to ensure proper overlap and even lawn coverage. ![]() Then apply back and forth in the longest direction.įor Irregular-Shaped Lawns: Apply one header strip around the entire lawn for a turning area, then apply back and forth. Store your spreader in a clean dry place.įor Rectangular Lawns: Apply two header strips across each end for a turning area. Allow the spreader to dry thoroughly in the sun. Hot water may be required at times to remove stubborn residue. ![]() Pour leftover material back into the package and seal the package tightlyĪfter each use, wash thoroughly over the lawn to remove all material clinging to the spreader. If product lands on any hard surface such as a driveway, sidewalk, or road, sweep the product back onto the lawn to keep it from being washed into the storm sewers and ultimately surface waters.ĥ. When finished, sweep stray particles back onto lawn area. 4ft./sec.), then squeeze and hold trigger (See diagrams below)Ĥ. To apply product, begin walking at a steady pace (approx. Turn orange rate dial to correct setting listed in the Spreader Setting section on the back of each package of Scotts product under "Scotts® Broadcast/Rotary Spreaders"ģ. Fill hopper with Scotts® lawn product of your choiceĢ. Broadview Hts, scotts speedy green 3000 broadcast spreader manual OH 44147. Scotts®Turf Builder®EdgeGuard®DLX Broadcast Spreaderġ. What is setting for a Scotts Standard broadcast spreader using Sevin. Spreader with EdgeGuard in the off position. The EdgeGuard Feature blocks off the right side of the spreader pattern to prevent product from spreading onto non-lawn areas.Īutomatically adjusts the flow OFF rate to ensure even application. To activate EdgeGuard feature, slide lever to "On" position Raise the top half of the handle to the upright position and tighten the wing nuts by hand. (set application rate backside of spreader) Sidewalks and waterways - Less waste, less clean-up, less environmental impact Spreader Details: Applies product only where you want it - Keeps product off landscaping, driveways, Scotts®Turf Builder®EdgeGuard® DLX Broadcast Spreader A: Scotts Turf Builder Sun and Shade Mix Full Sun and Dense Shade when used according to label instructions this product will not pose a health threat to. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |